Filter
Top Products
18
Routine Maintenance
Turn Power and SmartTemp switches OFF.
Unplug power cord from the outlet and coil around Power
Cord Quick Release.
Remove and rinse tools in clean, running water, dry and
replace in the Tool Caddy.
Coil Flex Hose around storage brackets on Tool Caddy.
Remove Tank-In-Tank, dispose of dirty water. See Features
section, page 8-9.
Rinse out Tank-In-Tank and replace on the machine; Clean
out lint trap.
Clean out the Flow Indicator Filter each time it is used to
ensure best cleaning performance. Unscrew the Flow
Indicator Cap, lift out the Red Rotor and White Filter. Rinse all
three parts in tap water. Replace the filter and rotor. Replace
the Flow Indicator Cap; turn until snug, do not over-tighten.
Wipe all exterior surfaces with a soft cloth.
Store cleaner upright in a protected, dry area.
Note: ProHeat ClearView uses water and must not be
stored where there is a danger of freezing.
Freezing will damage internal components and
void the warranty.
When carpet is dry, vacuum again to remove hair and fuzz
the ProHeat ClearView may have loosened.
Tip:
SmartMixBottle
may be stored
with concentrate
ready for your
next cleaning job.
Make sure dial is
turned to the
Water Rinse
Setting when
storing.
O
N
O
F
F
Cap
Rotor
Filter
WARNING:
To reduce the risk of fire,
electric shock or injury
unplug from outlet
before servicing.
When filling bottle or
storing unit, set
dial to:
7.
8.
9.
1.
2.
3.
4.
5.
6.
10.