Filter
Top Products
This User’s Guide has been designed to help you
get the utmost satisfaction from your BISSELL
ProHeat. You’ll find assembly and operating
instructions, safety precautions, as well as
maintenance and troubleshooting instructions.
Please read this Guide thoroughly before
assembling your Deep Cleaner.
Pay particular attention to the product diagram, assembly
instructions, and part names. Locate and organize all parts
before assembly. Familiarize yourself with the parts and
where they go. Following this User’s Guide will greatly
enhance your ability to get the most performance from your
BISSELL ProHeat for many years.
Your
ProHeat comes in three, easy to
assemble components:
Upper Handle
Lower Handle
Tool Caddy
The only thing you will need to assemble your cleaner is
a Phillips head screwdriver.
Refer to Assembly Diagram on page 5
1.
Slide Upper Handle onto Lower Handle.
2. Feed bundled power cord through Tool Caddy from
caddy’s flat side.
3. Align Upper Handle holes and Tool Caddy holes.
4. Place hex nut into back of Tool Caddy and hold in
place. Insert bolt from front to back turning into the
hex nut until snug. Do not over tighten. Repeat for
the second bolt and hex nut.
5. Insert 2 screws into lower 2 holes. Turn until snug.
6. Snap tools into Storage on the Tool Caddy.
7. Wrap Power Cord and Flex Hose as shown in
figure 7.
ProHeat assembly is now complete.
WARNING:
Do Not plug in your
cleaner until you have
completely assembled it per
the following instructions
and are familiar with all
instructions and operating
procedures.
How to Use this Guide
Assembling Your ProHeat
O
N
O
F
F
7
1 2
3 4
5
O
N
OFF
6
6
www.bissell.com 800.237.7691
ug310-5868_1699_306.indd 6ug310-5868_1699_306.indd 6 3/1/06 3:13:44 PM3/1/06 3:13:44 PM