Filter
Top Products
4. Fill the Water Tank with Hot Tap Water and Set Aside.
5. Attach the Bare Floor Tool onto the Floor Nozzle with
the long tab to the right side of the Floor Nozzle. First
attach left side (short tab) catching tab over nozzle
edge. Gently bend long Tab (right side) outward to
easily snap over edge of clear nozzle on left.
6. Set the Ready Tools Dial to Floor Cleaning.
7. Set the SmartMix Dial to Normal Clean.
8. Plug into an outlet and turn the Power Switch and
Heater ON ( I ).
9. Slowly move the machine forward and back over
bare floor surface one time while pressing trigger.
Caution: Do not overwet.
10. Repeat the motion without pressing the trigger.
This allows the Bare Floor tool to squeegee and
suction up the dirty water.
11. Allow approximately 30 minutes for floors to dry.
12. Remove Bare Floor tool and rinse and dry
before storing.
13. If any formula remains in the Formula Tank, pour
it back into the Hard Floor Solutions bottle for use
the next time.
14. Rinse out the Formula Tank.
Bare Floor Cleaning (Continued)
Troubleshooting / User Maintenance
SmartTemp Ready Light does not illuminate.
Possible Causes Remedies
1. The SmartTemp Switch is not turned ON ( I ). 1. Turn ON ( I ) the SmartTemp
Switch.
2. The machine Power Switch is not 2. Both switches must be ON ( I )
to turned ON ( I ). to activate the SmartTemp
Ready Light.
Reduced spray or no spray.
Possible Cause Remedies
1. Bladder may be empty. 1. Refill Bladder with hot tap water.
2. SmartMix Tank may be empty. 2. Fill with BISSELL Fiber Cleansing
Formula for cleaning. Fill with
water if rinsing or using the
Scotchgard applicator.
3. The filter may be clogged. 3. Clean out Flow Indicator Filter,
page 12.
4. Tanks may not be seated properly. 4. Turn power OFF (O); remove &
reseat tanks.
5. Pump may have lost prime. 5. Turn power OFF (O); after 1
minute turn ON and press
Trigger.
Bare Floor
Cleaning Tool
Bottom Front Edge
of Floor Nozzle
Snap Together
WARNING:
To reduce the risk of fire,
electric shock or injury
unplug from outlet before
servicing.
16
www.bissell.com 800.237.7691
ug310-5868_1699_306.indd 16ug310-5868_1699_306.indd 16 3/1/06 3:14:03 PM3/1/06 3:14:03 PM