Filter
Top Products
8
Remove dry filter bag from ball cage.
Remove concentrate measuring cup from filling cavity on
side of tank unit.
Pour two gallons of hot tap water (temperature should
not exceed 120° F/48° C) into filling cavity until level
reaches bottom of three vertical lines in tank unit.
Shake bottle of BISSELL Carpet Care. Fill measuring lid to
fill line (10 ounces). Empty measuring lid into filling cavity
and replace measuring lid.
Plug power cord into approved grounded outlet.
Pre-treat highly soiled areas: Press on pump/spray
switch, hold floor nozzle 4” - 6” above soiled carpet, and
pull trigger to spray cleaning solution.
Wait 5-10 minutes. Scrub tough stains with floor nozzle
brush.
Turn on pump/spray and vacuum/suction switches. Place
floor nozzle directly on carpet at arm’s length. Pull trigger
to spray cleaning solution while pulling wand toward you.
Repeat, keeping floor nozzle firmly against carpet
surface. Continue until no more dirt can be removed.
Do not overwet.
Release spray trigger. Vacuum area until no more
cleaning solution can be removed.
Continue to clean entire carpet, working in 3’ x 4’ sections.
If the machine loses suction, stops spraying and/or motor
noise rises in pitch, empty the tank [see WHEN YOU’RE
DONE, page 9]. Failure to empty tank will damage unit.
If floor nozzle stops spraying, turn off pump immediately
and check cleaning solution level. Never run pump dry.
Pre-treating
1.
2.
5.
1.
2.
1.
Deep Cleaning
3.
4.
Getting Ready
How To Deep Clean Carpet
2.
3.
4.
5.
6.
Tip:
Use only BIS-
SELL Carpet
Care in this
appliance. Use
of cleaning for-
mulas which
contain lemon
or pine oil may
damage this
appliance and
void warranty.
Tip:
Deep cleaning
stairs and high
traffic areas on
a regular basis
can prolong
carpet life.
Vacuum/suction switch
Pump/spray switch
Measuring
Cup
Remove Measuring Cup
From Filling Cavity
Filling Cavity