Filter
Top Products
To begin cleaning
1. Plug your SpotBot in. The Power light will illumi-
nate instructing you that there is power to the
unit and it is ready to go.
2. Place the filled Clean/Solution tank onto the
unit.
Handsfree cleaning
1. Place the unit directly over the spot or stain,
making sure the stain is in the center of the
handsfree cleaning area.
2. Select which cleaning cycle (surface stain or
set-in) you would like to begin with. Your
SpotBot will begin spraying, brushing and
suctioning up the spots and stains, in its
pre-programmed cycle. Both cycles have
been tested and proven to deliver superior
cleaning results, taking the guesswork out of
cleaning for you.
NOTE: If your unit has a built in heater (not
standard on all models) press the heater
button to turn on the heat feature.
3. When the cleaning cycle you have selected
is complete, the SpotBot will beep. The beep
will continue until you hit the STOP button.
4. Pick up the unit and check the area that
was cleaned.
5. If you have used Oxy GEN2, this chemical
will continue to work for the next six to eight
hours, cleaning your spots and stains all the
way to the backing of the carpet.
Operation
9
www.bissell.com 800.237.7691
Tip:
Some difficult stains may
require that you run the
cleaning cycle a second
time.