Filter
Top Products
Hose cleaning
1.
Before turning off the SpotBot, suction up
clean water to thoroughly rinse out the
inside of the vacuum flex hose. Then, lift
the vacuum flex hose upwards to drain any
remaining water into the dirty tank.
2. Disconnect the cleaning tool from the
vacuum flex hose by pushing down on the
button lock and pulling straight off (do not
twist tools to remove them).
3. Once the tool is removed from the vacuum
flex hose it can be cleaned by rinsing under
clean running water.
Storage
1.
Unplug the power Cord from the outlet. Wrap
power cord around the cord wrap.
2. Empty and rinse the dirty/collection tank
after each use, or when dirty water reaches
the indicated maximum fill line. To remove
the tank, lift up the dirty tank latch and pull
the tank out. Dump out the dirty water and
rinse with clean. Replace the tank into the
unit for storage. After using the SpotBot’s
handsfree feature, wipe the window and
brushing area with a soft cloth.
3. If you were using your SpotBot manually, wrap
the vacuum flex hose around the unit and
secure the spray trigger into the receiver on the
front of the unit.
4. Store unit indoors at room temperature
(40° to 110°F).
11
www.bissell.com 800.237.7691
Maintenance and care
Tip:
If a significant amount of
water and solution(s) remain
in the clean tank, your unit
can be stored with liquid in
the clean tank. However, if
you have added Oxy GEN2
into the clean tank, fresh
Oxy GEN2 should be added
prior to the next use to
optimize performance.
Tip:
Clean out the Black Valve
periodically inside of the
Dirty/Collection Tank.