Filter
Top Products
When the cleaning cycle you have selected is
complete, the SpotBot will beep. The beep will
continue until you hit the STOP button.
Pick up the unit and check the area that
was cleaned.
If you have used Oxy GEN2, this chemical will
continue to work for the next six to eight hours.
Cleaning your spots and stains all the way to
the backing of the carpet.
Before turning off the SpotBot, vacuum up clean
water to thoroughly rinse out the inside of the
Vacuum Flex Hose. Then, lift the Vacuum Flex Hose
upwards to drain any remaining water into the
Dirty Tank.
Disconnect the cleaning tool from the Vacuum Flex
Hose by pushing down on the button lock and pulling
straight off (do not twist tools to remove them).
Once the tool is removed from the Vacuum Flex
Hose it can be cleaned by rinsing under clean run-
ning water.
1.
2.
3.
1.
Tip:
Some difficult stains may
require that you run the
cleaning cycle a second
time.
For Handsfree Cleaning
When You're Finished
For Manual/Hose Cleaning
2.
3.
3.
11
ug203-6650_1200_805.indd 11ug203-6650_1200_805.indd 11 11/1/05 11:44:30 AM11/1/05 11:44:30 AM