Bissell 1200 Vacuum Cleaner User Manual


 
Remove the Hose from the unit by depressing the
Release Button.
a. Remove the Tough Stain Brush from the back
of the unit.
b. Attach the Tough Stain Brush onto the grip of
the Flex Hose.
Select the Manual/Hose button on the control
panel to start the SpotBot.
NOTE: In manual mode, the SpotBot will not
turn on until the grip is removed from the
unit. If it is not removed within 30 seconds of
pushing the start button, the unit will shut off.
Begin cleaning by holding the tool no more than
six inches above the soiled surface. Depress the
Spray Trigger for about 5 seconds to apply the
cleaning solution to the soiled area. Release the
trigger. Be careful not to over wet.
Using the brush on the tool, gently scrub the soiled
area for about 30 seconds or until the soiled area
appears to be clean.
To suction up the dirt and cleaning solution,
position the suction nozzle over the cleaned area,
apply downward pressure on the tool, and pull
nozzle toward you. You should see the dirty
solution pass through the nozzle. Continue until no
more solution can be removed. Normally, this step
will require no more than one minute of back and
forth passes.
If the stain is still visible, repeat steps 4-6
as necessary.
When the cleaning is complete, lightly drag the
suction nozzle across the stain for about two
minutes to further aid in drying the cleaned area.
Press the Manual/Hose button to turn off
the SpotBot.
Unplug the machine, wrap the cord on the cord
wraps and wrap the hose around the machine so
that the wand can be placed in the holder for
convenient storage.
Tip:
Check upholstery stuffing
before cleaning. Colored
stuffing may bleed through
the fabric when it becomes
wet.
Tip:
One of the effective
ingredients in Oxy GEN2 is
Hydrogen Peroxide. Certain
people may be affected by
the product when it comes
into contact with their skin;
it may turn the skin white
and/or cause tingling.
Washing your hands after
use and applying hand
lotion will remove any
possible white discoloration.
1.
5.
3.
4.
2.
For Manual/Hose Cleaning
Tip:
If the unit accidently tips
or is tilted, the Handsfree
Cleaning Brushes will stop.
3.
2b.
1.
2a.
10
6.
7.
8.
9.
10.
ug203-6650_1200_805.indd 10ug203-6650_1200_805.indd 10 11/1/05 11:44:29 AM11/1/05 11:44:29 AM