Filter
Top Products
the Power Knob to I. In about 2-3 minutes, the
humidifier will begin to produce moisture.
6. If the refill light remains lit, unplug the
humidifier and wait a further 5 minutes.
IMPORTANT:
If you do not plan to use the humidifier for two or
more days, make sure any residual water is
drained from the water tank and base to prevent
algae or bacteria growth.
Replacing the Water Purification Filter
The water purification filter is used to retain
minerals in your water and provide a clean
moisture output. The filter life is determined by
the average daily use of your humidifier and the
water hardness in your area. Areas with hard
water will require more frequent replacement of
the filter. It is strongly recommended that the filter
be replaced at least every 2-3 months (depending
on use) or when the heating element is starting to
gather minerals on it.
To Replace the Filter:
1. Switch the humidifier to 0 - off and unplug.
Remove the tank, drain any water from the
base, lift out the used filter, and throw it away.
2. Remove the protective bag from the new filter
and pre-soak the filter under a cold running tap
for 1 minute. Place the soaked filter into the
base (see Figure 2) and replace the tank
allowing at least 5 minutes for the water to
pass before switching the unit ON (I).
Cleaning and Maintenance Instruction
The following maintenance procedures must be
routinely followed in order to ensure proper,
efficient operation of your humidifier. The unit
WILL FAIL if it is not cleaned properly.
Regular cleaning prevents scale build-up on the
heating element and tray. It also prevents micro-
organisms from growing on the tray and tank. This
ensures that maximum efficiency will be achieved.
We cannot over-emphasize how essential proper
cleaning is to the maintenance and continued use
of your unit and the avoidance of algae or bacteria
build-up.
Regular Maintenance
The frequency of maintenance will depend on the
average daily use of your humidifier and the water
hardness of your area. It is recommended that
this procedure is carried out weekly or more
regularly if necessary.
1. Before cleaning, set the control to 0 - off
position and unplug the unit from the electrical
outlet.
2. Remove the water tank then unlock the misting
chamber by rotating the safety lock. Lift mist
chamber from the unit's base. Now lift the tray
from the base.
3. Empty water and minerals from the tray and
wash it through to remove any sediment and
dirt that has accumulated in the tray.
NOTE: It is imperative that the tray is cleaned
properly. The tray is dishwasher safe for easy
cleaning (Top rack of the dishwasher only).
4. Rinse out the tank out and refill with clean cool
water.
5. Wipe the heating element clean with a soft
cloth after it has had a chance to cool.
WARNING: If the misting chamber is left
assembled to the humidifier, it may take up to an
hour before the heating element is sufficiently cool
to be touched.
This humidifier heats the water producing a clean
moisture. Some of the impurities from the water
are collected in the Heating Chamber. The
Electronic Thermal Control Heating element is
lined with a Teflon coating that is designed to
provide the easiest cleaning to prolong the
operating efficiency of the humidifier.
DO NOT use any metal or hard objects to clean
the Heating Element. The coating can be
scratched if cleaned improperly.
Never use detergents, gasoline, kerosene, glass
cleaner, furniture polish, paint thinner or other
household solvents to clean any part of the
humidifier.
De-scaling Maintenance
• Scale needs to be removed as it becomes
noticeable. We recommend using Bionaire
TM
Clean Away - Humidifier cleaning solution.
• Apply Solution with a plastic brush to scale
surfaces. Let it soak until residue is softened.
For cleaning the tank, mix 2 capsules of
solution with 2 litres of water. Let mixture stand
for several minutes, swishing every few
minutes. Drain solution and THOROUGHLY
RINSE the tank.
If not available follow these instructions:
1. Repeat steps 1-3 in the Maintenance section.
2. Clean the tray by partially filling the tray with
200ml of undiluted white vinegar. If the
element is heavily scaled, plug the humidifier
into an electrical socket and turn it ON for no
longer than 15 seconds. After this time turn the
humidifier OFF and unplug it from the electrical
outlet.
Let solution stand 20 minutes, cleaning all
interior surfaces with a soft brush. Dampen a
cloth with undiluted white vinegar and wipe out
entire tray to remove scale.
3. Rinse with clean warm water to remove scale
and the white vinegar solution before
beginning to disinfect the tank.
4. Wipe the heating element clean with a soft
cloth after it has had a chance to cool.
Disinfect tank:
1. Fill tank with 1 teaspoon of bleach and 3.5
litres of water.
2. Let the solution stand for 20 minutes, swishing
every few minutes. Wet all surfaces.
3. Empty the tank after 20 minutes, and rinse well
with water until the bleach smell is gone. Dry
with some paper towel.
4. Refill the water tank with cool water; replace
the water tank. Repeat Operating Instructions.
Storage Instructions
If your humidifier will not be in use for two days or
more, or at the end of the season follow these
instructions.
1. Clean, rinse and thoroughly dry the humidifier
as directed in the De-scaling Maintenance
section. DO NOT leave any water inside the
base or tray.
2. Remove the reservoir cap. Do not store with
the reservoir cap in place.
3. Remove and throw away the filter
4. Place the humidifier in the original carton and
store in a cool, dry place.
5. Clean the humidifier before the next season
begins.
6. Order a replacement filter to start the next
season.
SERVICE INSTRUCTIONS
1. Do NOT attempt to repair or adjust any
electrical or mechanical functions on this unit.
Doing so will void the warranty. The insides of
the unit contain no user serviceable parts. Only
qualified personnel should perform all
servicing.
2. Should the unit stop working, first check the
fuse in the plug (UK only) or fuse/circuit
breaker at the distribution board is operating,
before contacting the manufacturer or service
agent.
3. If you need to exchange the unit, please return
it in its original carton, with a sales receipt, to
the store where you purchased it.
4. Should your humidifier require service, please
contact your local dealer.
ACCESSORIES FOR MODEL BWM5075
• WMF-50 Water Purification Filter
•We recommend the use of a Bionaire™ /
Hygrometer/ Thermometer, model NO: BT400,
to read the indoor room temperature and
humidity level.
• Bionaire™ Cleaning Solution
TECHNICAL SPECIFICATIONS
Input voltage: 220-240 V~ 50 Hz
Power consumption: 400 Watts (max)
The Holmes Group reserves the right to change
or modify any specifications without notice.
THIS PRODUCT IS MANUFACTURED TO
COMPLY WITH THE E.E.C. DIRECTIVES
73/23/EEC and 89/336/EEC.
For U.K. and Ireland only:
If the plug is not suitable for the socket outlets in
your home, it can be removed and replaced by
a plug of the correct type.
Please refer to "Installation of a plug" below.
Installation of a plug Applicable to
U.K. and Ireland.
WARNING - THIS APPLIANCE MUST BE
EARTHED
The wires in the mains lead are coloured as such:
GREEN AND YELLOW - EARTH
BROWN - LIVE
BLUE - NEUTRAL
Please note that the colour of these mains wires
may not correspond with the colour markings
that identify the terminals in your plug.
Please proceed as follows:
The wire which is coloured GREEN AND YELLOW
must be connected to the terminal which is marked
with the letter 'E' or by the earth symbol or
coloured GREEN or GREEN AND YELLOW.
The BROWN coloured wire must be connected
to the terminal, which is marked with the letter
"L" or is coloured RED.
The BLUE coloured wire must be connected to
the terminal, which is marked with the letter "N"
or is coloured BLACK.
54
BWM5075/5075CI/IUK04M1 v.qxd 3/23/04 9:42 AM Page 9