Filter
Top Products
SYNC more than 1 unit at once. A hazardous situation
may occur.
Note: If the batteries are running low on power, a low
battery indicator will appear on the remote. Low batteries
will affect transmission distance and the screen contrast.
We recommend replacing batteries immediately.
Note: The maximum transmission distance for this remote
is 30 ft., Do not use remote more than 30 ft. from
appliance. Remote must be used in same room as
appliance.
Note: Galileo™ can be used in either Fahrenheit or
Celsius. To change the reading on the remote, flip the
remote over and push the button located on the right hand
side under the stand with a ball point pen tip. This switch
will change the reading from °F to °C and vice versa.
Note: Every minute while in Auto mode, the Galileo™
communications with the base unit. If the Galileo™ goes
out of range and/or has low batteries, the communication
will stop, and after 8 minutes of non-communication the
unit will shut off.
MANUAL OPERATION WITH REMOTE
1. Press Mode button on the remote. "Low" illuminates
on remote screen indicating mode. The power light
on the unit will turn on. The unit turns on and
operates in "Low" mode. The units "Low" light will
illuminate. In this mode, the unit will continuously run at
its low wattage.
2. Press Mode button on remote a second time. The
remote screen will now display "High" (1500 Watts).
The unit’s "High" light will illuminate and the unit will
run in this mode. In this mode the unit will
continuously run at 1500 Watts.
mode
Figure 2
5
Note: While using the remote, the backlight function will
turn on when any button is pushed and will turn off after
10 seconds of non-use.
Note: Do not cover remote while in use, this may affect
the accuracy of the temperature reading.
Note: Do not place remote under lamps as the radiant
heat from the lamp may affect the accuracy of the
thermostat.
Note: Because heat rises, and the Galileo
TM
remote senses
temperature, Bionaire recommends that you do not locate
the Galileo
TM
remote higher than 4ft from the ground. By
locating the Galileo
TM
more than 4 ft from the ground, you
will get a less accurate temperature reading than under
normal circumstances.
Note: Do not place remote on control panel while in use.
THERMOSTAT OPERATION WITH REMOTE
1. Press Mode button on remote until the remote screen
displays "Auto" and "low". The "Set" temperature is
displayed next to the "Room" temp. The unit will cycle
on and off to maintain the "Set" temperature. The
default room temp = 72ºF. In this mode the unit will run
to maintain the "Set" temperature.
2. Press Mode button on remote again. The remote
screen displays "Auto" and "high". The "Set"
temperature is displayed next to the "Room" temp.
The "Auto" light on unit stays illuminated. The unit will
cycle on and off to maintain the "Set" temperature at
high wattage (1500 Watts).
3. To turn unit "Off", press the Mode button and the LCD
will go blank (except for the "Room" temperature
display which is always displayed while batteries are in
the remote) and the unit will shut off.
Note: It is normal for the heater to cycle on and off as it
maintains the preset temperature. To prevent the unit from
cycling, you need to raise the thermostat setting.
ADJUSTING SET TEMP:
1. When in "Auto" mode, press the (+) button on the
remote. The "Set" number will increase with each
press. Hold the button down to scroll. The minimum
temp is 55ºF and the maximum is 85ºF. The unit scrolls
one digit at a time in a continuous loop. 55º, 56º…, 84º,
85º, 55º, 56º….
6