Filter
Top Products
Form No F060711D 9 Part No 840245
MV650SPH Self-Propelled Vacuum Owner’s Manual
OPERATION
OPERATOR CONTROLS
The operator’s position is at the rear of the machine between the handlebars. The operator should STAND in a position to allow
both handlebars to be grasped firmly, which allows sufficient leverage to steer the machine. Operator’s controls are shown below.
Operator Control Locations
1 Drive Clutch Lever 4 Throttle Control
2 Bag Latch 5 Drive Shifter Control
3 Pull Starter 6 Nozzle Door Adjuster
STARTING
CHECK engine oil level before operating machine.
1. Place equipment on a level, firm surface that is free of rocks or other debris.
2. Place throttle in START position.
Throttle
DO NOT START equipment without the debris bag in place.
1
2
3
4
6
5