Filter
Top Products
Part No. 890311 Form No. F010396C
Page 3 of 12
These items should be included in your carton. If
any of these parts are missing, contact your dealer.
Check
Debris Bag
890304
Quick Disconnect
Fig. 2
For your safety and the safety of others, these directions should be followed:
Use of Ear Protection is recommended while
operating this machine.
Do not operate this machine without first reading
owner's manual and engine manufacturer's manual.
Use of Eye and Breathing protection is recom-
mended when using this machine, especially in dry
and dusty conditions. Optional bag cover directs dust
toward ground, away from the operator.
·DO NOT place hands or feet inside nozzle intake opening,
near debris outlet or near any moving parts.
·DO NOT start engine without debris bag and quick discon-
nect connected firmly in place to exhaust outlet.
·DO NOT start or operate machine with debris bag zipper
open.
PUT OIL IN ENGINE BEFORE STARTING.
Read all safety and operating instructions
before assembling or starting this unit.
·DO NOT operate during excessive vibration.
·DO NOT remove bag until engine has been turned off and has
come to a complete stop.
·DO NOT remove hose kit cap on nozzle until engine has been
turned off and has come to a complete stop.
·DO NOT operate machine with hose cap, bag or hose removed.
·DO NOT use this machine for vacuuming exclusively sand,
dust, fine dirt, rock, glass, string like material, grain, rags,
cans, metal, bark or water.
·DO NOT operate this machine on slopes greater than 20%.
·DO NOT pick up any hot or burning debris, or any toxic or
explosive material.
·DO NOT allow children to operate this equipment.
GENERAL SAFETY
ASSEMBLY
Your Billy Goat is shipped from the factory in one carton,
completely assembled except for the upper handle, debris bag,
and bag quick disconnect.
Check
Connector
Quick
Disconnect
890176
Literature
Assy
Check
Literature Assy
890320
Per Model
Engine
Manual
PACKING CHECKLIST
99
99
9
1010
1010
10
1111
1111
11
Check
Briggs & Stratton
P/N MS9984 Multi-Lang.
1. ASSEMBLE Lift upper handle (item 6) and remove items 8, 19, 30, & 46
from lower handle (item 27). Attach upper and lower handles as shown, and
securely tighten folding handle knobs(item 46),while holding head of
screw(item 8) firmly against upper handle.
2. UNFOLD the debris bag (item 1) and fasten bag neck to bag quick
disconnect (item 83). Attach firmly to housing exhaust (item 52) see fig. 2.
3. ATTACH bag hanger strap to bag supports (item 11), preassembled to
upper handle.
4. CONNECT spark plug wire.
6
27
8
30
46
19