Filter
Top Products
Manual 2100-517
Page 7 of 11
MIS-2651
INSULATION.
OUT TO DSH COIL INLET
HEATER
OUTLET
AND WRAP WITH PROVIDED
OUTLET THERMISTOR
NOTE: REMOVE DURING TUBE
AND WRAP WITH PROVIDED
SOLDERING, THEN RE-INSTALL
INSULATION.
AIR.
SOLDERING, THEN RE-INSTALL
NOTE: PUMP IS NOT SELF-PRIMING, IT I S
RECOMMENDED TO MANUALLY BLEED-OFF
NOTE: INSTALLER MUST INSURE THAT THE INLET THERMISTOR
IS RE-LOCATED BACK TO THE INLET TUBE AND THE OUTLET
THERMISTOR IS LOCATED BACK ON THE OUTLET TUBE.
VERIFY BY CONNECTIONS ON CONTROL BOARD
INLET FROM WATER
INLET THERMISTOR
NOTE: REMOVE DURING TUBE
AIR PURGE PORT
FROM DSH COIL
OUT TO WATER HEATER
Figure 2
AIR PURGE PORT