Filter
Top Products
8
HEAT AND MOISTURE (SECONDARY CONTROL):
Heat and/or moisture can be further controlled by sliding
damper, located at top of cabinet, left or right to desired
opening.
CLEANING PROCEDURES
LEDGE REMOVAL:
! Lift up and out of holes in ledge uprights.
HEATER ASSEMBLY REMOVAL:
!
!
!
Open door and allow sufficient time for cool
down.
Unplug heater cordfrom receptacle.
Carefully slide heating unit forward. (If in proofing
mode and pan has water remaining, avoid water
movement to prevent spillage. After unit is totally
out and on a stable surface, remove water pan
and pour outremaining water.)
When returning heater assembly to its operating
position, be sure to line up back end with bottom of
louvered air tunnel. (If returning unit to proofing mode,
add water only after unit is fully inserted and in operating
position.)