Filter
Top Products
6
ELECTRICAL RATING
For models equipped with 120V, 60HZ, 1PH
ELECTRICAL CONNECTION:
The cabinet heating unit has a 2000-watt heating element
and requires a 20-amp circuit. If required circuit is not
available, wiring should be performed by a qualified and
certified electrician.
For models equipped with 220V, 50HZ, 1PH
ELECTRICAL CONNECTION:
Equipped with a female “IEC 60320 C20” Power inlet which
accommodates various power cord configurations for
applicable country. The cabinet heating unit has a 2000-
watt heating element and requiresa 9-ampcircuit.
NEMA 5-20R
20 AMP RECEPTACLE
IEC 60320 C20 POWER INLET (9 amp)
.
LOCATION
Your unit should be located to provide easy access, without restrictions. Factory installed door opens from
leftto right.Provisions formounting doorto openfrom rightto left are incorporated.
Electrical outlet must be less than (6) ft. from unit operating position. Avoid enclosed or confined locations,
which will restrictair circulation.
1.) Locate andremove cord holder bracketon topof heaterbody insidecabinet. Seefigure 1.
2.) Remove (2) screws fromupper rightrear ofcabinet forlater installation See figure2.
3.) Install bracket with (2) screwsand tighten.See figure3. Completedinstall see figure4.
Electrical Cord HolderInstallation
Figure 1 Figure 4Figure 3Figure 2
OPERATING PROCEDURES
CONTROL PANEL CONFIGURATION
ELECTRICAL