Filter
Top Products
6
Tango
Install the pin onto the diverter.
Press the guide bushing firmly into place. The hole in the
pin should be clearly visible through the slot in the guide
bushing.
Press the diverter assembly firmly into the spout tee until it is
fully seated. Turn the guide bushing so that the slot faces the
rear of the spout.
Limbo
Screw the socket onto the diverter.
Insert the ball rod into the socket.
Press the white plastic retainer clip over the ball rod. Press into
place over the socket.
Press the diverter assembly firmly into the spout tee until it is
fully seated.
Firmly press the spout over the tee and
diverter. Tighten the set screw with the
included 3 mm Allen wrench.
CAUTION: do not overtighten the set
screw or the o-rings on the diverter will
deform, which will cause a leak.
Use the included wrench to hold
the threaded rod steady. (It may be
necessary to use a needle-nosed plier to
pull up on the threaded rod to expose the
wrench flats).
Install the diverter knob.