Filter
Top Products
5
Interaktiv and Swing
Screw the nut onto the diverter. Screw the shorter threaded end of
the threaded rod into the nut. Slide the rod trim onto the rod and
screw into place so that a few threads protrude from the top.
Firmly press the diverter assembly straight into the spout tee until it
is fully seated.
Swing only: install the spout deco ring on the
spout. Make sure that the set screw hole in the
deco ring lines up with the set screw hole in the
spout.
Press the spout over the tee and diverter. Install
the set screw and tighten it with a 3mm Allen
wrench (included).
CAUTION: do not overtighten the set screw or
the o-rings on the diverter will deform, which will
cause a leak.
Install the diverter knob.