Filter
Top Products
15
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
RS-232
Connection
RS-232 is connected through a 9-pin female DB connector. Only pins 2, 3, and 5 are terminated.
No. Pin Function
1 ---- Not used
2 Tx Transmit
3 Rx Receive
4 ---- Not used
5 Gnd Ground
6 ---- Not used
7 ---- Not used
8 ---- Not used
9 ---- Not used
1
2
3
4
5
9 8 7
6
Set Up
To set up the RS-232 hyperterminal (if not using 3rd party software) use the following steps:
1. Connect the matrix to a PC using a 9pin to 9pin cable
2. Go to the Device manager folder (see picture A)
3. Find the Matrix COM port and right click with a mouse and select properties (see picture B)
NOTE: If unsure which COM port is the matrix, unplug the 9pin cable and plug it back in. It
will disappear and reappear on the COM port list.
4. Under the properties menu select the port settings tab and update the menu to the matrix
default settings of: Bits Per Second: 115200, Data Bits: 8, Parity: None, Stop Bits: 1 and Flow
Control: None. (see picture C)
Set up is done and any hyperterminal program may be used to control the matrix now.
A
B
C