Filter
Top Products
OPERATION
Page 3
eBoss™ Electronic Lockset
BASIC OPERATION
The outside lever is always locked except when the lock is in passage mode. The eBOSS™ allows up to 94
individual user codes to be valid. Codes may be from two to seven digits in length, and digits may be repeated.
All programming is accomplished easily from the keypad utilizing LED and audible guidance. Changing codes
takes only a matter of seconds for an authorized user.
• User enters a valid code (2-7 digits) followed by the [
*
] key.
• Lock will unlock (green LED) for a user definable duration of 1-255 seconds (default 4 seconds), then re-lock.
• If lock is in lockout mode, the yellow LED will light, indicating denied entry.
If enabled, the green LED will light upon each depression of a key and for the duration that the lock is unlocked.
If the audible sounder is enabled, it will beep concurrently with the LED as keys are depressed. If an invalid code
is entered, the red LED will light and an audible sound sequence of one long beep, followed by four short beeps,
will indicate denied entry.
PROGRAMMABLE FEATURES
All standard programming of the eBOSS is easily performed through the keypad.
• Master Code – Assigns Supervisor Code and Emergency Code.
• Supervisor Code – Allows all programming of the controller except for changing Master Code.
• User Codes – Used for standard entry. 94 User Codes may be programmed into the eBOSS.
• Emergency Code – Allows emergency entry of the lock system when the controller low battery voltage is in the
“black out” condition or if the lock is in the Lockout mode.
• Lockout Code – Restricts User Codes from the ability to gain access. Only the Supervisor Code and Emergency
code can override.
• Passage Code – Enables the passage feature, maintaining the lock unlocked.
• Key Press Feedback - Enables or disables the LED indicators or audible sound features of the lockset.
• Factory Code Reset – Resets all user definable functions to factory default settings. Will not reset Specialty
Codes or User Codes.
• Re-Lock Duration – Adjusts the duration the lock remains unlocked from 1-255 seconds. Default is 4 seconds.
• Keypad Lockout – Deters tampering by disabling the keypad after three successive failed attempts or after 25
successive key presses without a valid code. Default is 10 seconds but user programmable from 1 to 255
seconds.
• Secure – Normal locked state. Any assigned user code can gain access.
• Lockout – Lockset will not accept any assigned user codes except for the Supervisor and Emergency Codes.
• Passage – Unlocked state
OPERATIONAL MODES
BATTERY REPLACEMENT
The inside battery cover is easily removed for battery replacement. Each lock contains six alkaline “AA” batteries,
which typically last for 100,000 cycles.
FUNCTIONS
E5496LN - Mechanical key can be used to retract latchbolt for entry
E5486LN - Non-key override