AQUATIC INDUSTRIES, INC. 9
We recommend you use a very small amount of delicate washing detergent. Start with only a few drops and
add more as necessary. Be advised that some washing detergents foam excessively when agitated. Exercise
moderation in experimenting with different soap products.
No servicing of this product should be done by the user. There are no user serviceable parts. These are the
only controls that should be used by the consumer. Do not change or alter any of these controls under any
circumstances.
Motors are self-lubricating -- No lubrication required.
This equipment generates and uses radio frequency energy and if not installed and used properly, that
is, in strict accordance with the manufacturers instruction, may cause interference to radio and television
reception. It has been type tested and found to comply with the limits for a class B computing device
in accordance with the specifications in subpart J of part 15 of the FCC rules, which are designed to
provide reasonable protection against such interference in a residential installation. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause
interference, which can be determined by turning the equipment on and off, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient the receiving antenna
• Relocate the receiver with respect to the sink.
• Move the receiver away from the sink.
• Plug the receiver into a different outlet so that the receiver and bath are on different branch cir-
cuits.
• If necessary, the user should consult the dealer or an experienced radio/television
technician for additional suggestions.
• The user may find the following booklet prepared by the Federal Communications
Commission helpful: “How To Identify and Resolve Radio-TV Interference Problems.”
This booklet is available from the U.S. Government Printing Office, Washington, DC 20402, Stock
No., 004-000-00345-4.
USER INFORMATION
FCC CONSUMER INFORMATION
Electrical installation information listed on page 7.
Model Number &
Serial Number Location
The sink model and serial number are located
on the frontside underneath the sink.
Your installer should have a service access
panel in this location. Look for a label which
resembles the one on the right.