Filter
Top Products
– 23 –
Once the thermostat panel has been opened and removed from the base, turn the thermostat over
and locate the DIP switches found on the circuit board according to the following drawing:
Be careful to change only the intended DIP switches per
the explanation given at the beginning of this section.
After the DIP switches have been set to the desired
position, carefully reassemble the thermostat.
a) Place the cover on the base by lining up the 2 round
pegs on the bottom of the cover with the half circle
cutouts on the top of the base.
Note that the bottom of the
cover when fully open
slides in behind the top
of the base. Swing the
cover fully open. The
cover will stay in place.
110-948 7/12/01 10:16 AM Page 25