Filter
Top Products
3InRoom SC 50 Hz User Guide
Safety
Electrical Hazard: Connect the equipment to a 220-240V, 50Hz, three prong grounded outlet
(two poles plus a ground). The use of a time-delay fuse or time-delay circuit breaker is
recommended. Connection to any other power source may result in a shock hazard or damage to the
cooling unit.
Do not cut or remove the ground from the power cord plug.
Use the cooling unit with the supplied power cord only.
Do not use an extension cord with this cooling unit.
If the plug gets hot, call a qualified electrician.
Do not immerse the cooling unit, cord or plug in water or any other liquid.
If the power supply cord is damaged, it must be replaced by the manufacturer or its service agent or
a similarly qualified person in order to avoid a hazard.
Warning: Do not stick anything into the air outlet of the cooling unit.
Children should be supervised to ensure that they do not play with the cooling unit.
The cooling unit is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the cooling unit by a person responsible for their safety.
Do not use in a room with poor air circulation.
Caution: Do not place the cooling unit on its side. If the cooling unit has been tipped, place it
upright on a flat, solid surface and keep it in this position for a minimum of 12 hours before
operating.
Use the cooling unit on a flat surface only.
Do not obstruct the cooling unit air outlets.
For indoor use only.
The equipment contains no internal user-serviceable parts.
Do not place the rear of the cooling unit closer than 500 mm (20 in) to any wall or obstacle.
Do not install the cooling unit where there are fumes or flammable gases, or in an extremely humid
space such as a greenhouse.
Do not place objects on top of the cooling unit or sit on the cooling unit.
Disposal: Do not dispose of the cooling unit as unsorted municipal waste. The cooling unit should
be collected as waste requiring special treatment.