Filter
Top Products
60
CONFIGURATION
The Burner Control can be congured from the OI Display. The
control conguration is grouped into the functional groups as
shown in Table 23.
HYDRONIC CONTROL
System Identication and
Access
CH - Central Heat
Outdoor Reset
DHW - Domestic Hot Water
DHW Storage
DHW Plate
Warm Weather Shutdown
Demand Priority
Modulation Conguration
Pump Conguration
Statistics Conguration
High Limit
Stack Limit
Delta T Limits
T-Rise Limit
Heat Exchanger High Limit
Anti-condensation
Frost Protection Conguration
Annunciation Conguration
Burner Control Interlocks
Burner Control Timings and Rates
Burner Control Ignition
Burner Control Flame Failure
System Conguration
Fan Conguration
Sensor Conguration
Lead Lag Slave Conguration
Lead Lag Master Conguration
Most of this conguration is performed by the Service Agent
or at A.O. Smith. Each functional group is displayed on the
Conguration menu page.
Parameters in functional groups that are not applicable for
the installation can be ignored. In some cases, features in a
functional group are disabled by default and are enabled when
needed for the installation.
SYSTEM SYNCHRONIZATION (S7999B OI DISPLAY ONLY)
The user can manually synchronize conguration data from the
connected controls at any time.
A new control is visible when conguration and status data is
gathered from it. This collection procedure takes a few minutes.
The control is marked as “Unknown” when no conguration
information exists. Normally, control conguration data collection
only needs to be performed when the control is initially installed.
However, a re synchronization is necessary after the OI Display
is reset. See Figure 76.
The user presses the Synchronize button to begin synchronization
with the control. See Figure 76.
Status of the synchronization is reected in the dialog box. The
synchronization can be aborted by selecting the Cancel button.
FIGURE 76. SYSTEM SYNCHRONIZATION
TABLE 23. FUNCTIONAL CONFIGURATION GROUPS