Filter
Top Products
Page -11-
CLARKE TECHNOLOGY 530 Upright Vacuum Operator's Manual
HOW TO ASSEMBLE
CAUTION: Fully assemble the unit before
using.
Hardware Package: The package contains two nuts
and bolts, one screw and one spring.
1. Assemble Lower Handle
Attach lower handle over socket, align holes and
fasten with bolt and internally threaded nut provided
in hardware package.
2. Attach Upper Handle
Place upper handle over lower handle align holes
and fasten with bolt and internally threaded nut
included in hardware package.
3. Install Line Cord Support and Bag Hook
Attach spring bag hook to rear upper handle tube.
Insert fitting end into rectangular hole. Align holes
and fasten with screw provided in hardware pack-
age.
4. Bag Assembly (OPTIONAL ACCESSORY)
Open zipper of paper bag cover. Attach spring
around dust bag connector located inside paper bag
cover (see figure 4). Slide paper bag tube over
connector and roll spring up to hold bag. Be sure
zipper printing on paper aligns up with zipper on
paper bag cover. Hold paper bag cover on back of
the unit with printing facing handle tube.
5. Install Bag to Upright Vacuum
Slide lower bag support into slots of bag support
guide, pressing right. Push bag support towards
inlet and turn knob clockwise. Insert top spring into
hook (see figure 5).
Figure 4
Figure 5
Top Spring
Paper Bag
Cover
Paper Bag
Tube
Spring
Lower Bag Support
Dust Bag
Connector
Line Cord
Support
and Bag
Hook
Bag
Support
Guide
Knob