Filter
Top Products
19
A DAMAGED OR MALFUNCTIONING PHOTOELECTRIC ACCESSORY
SYSTEM COULD ENABLE A GARAGE DOOR TO CLOSE ON PEOPLE
OR PROPERTY, CAUSING SERIOUS INJURY OR DEATH.
PERFORM THIS TEST MONTHLY TO ENSURE YOUR ALL-CLEAR IS
WORKING PROPERLY.
STEP 6: Operating the Deluxe Wall Station Controls — The Deluxe Wall Station replaces standard doorbell-type pushbuttons to
allow you to integrate fully with all the convenience and security features built into your Allstar 3000 Series garage door operator.
1. Operator Pushbutton — Red-backlighting. Used to start or stop the operator. The function of this pushbutton is automatically
disabled when the Security slide switch is set to the “ON” position and the door is
fully closed.
2. Operator Light Pushbutton —Yellow-backlighting. Turns the operator
light on and off, but does not activate the door operator. The operator light will
stay on until turned off using this pushbutton, or until door operation is initiated,
which overrides the function of this pushbutton and automatically turns the light
off after 4-1/2 minutes.
3. Security Switch — Prevents unwanted door operation from pushbutton, key
switches, keyless entry systems, radio controls, etc. When the Security Switch is
moved to the “ON” position, with the garage door fully closed,
signals from all of
these devices are locked out by the operator. Such devices will continue to work
until the door is fully closed, allowing you to set the switch (when leaving on
vacation, for example), leave the garage and close the door remotely.
(NOTE: YOU WILL NOT BE ABLE TO OPEN YOUR GARAGE DOOR
USING RADIO CONTROLS OR EXTERIOR ACCESS CONTROLS UNTIL
THE SECURITY SWITCH IS RETURNED TO THE “OFF” POSITION. THIS MUST BE DONE FROM INSIDE THE
GARAGE.)
When the Security Switch is engaged, the red light behind the Operator Pushbutton is extinguished as an indication. The Operator
Light Pushbutton will continue to function normally.
104394 Operator Pushbutton
Operator Light
Push button
Security
Switch
STEP 5: Testing the All-Clear™ Photosystem —
Start the door in the close travel direction and then
place an obstacle approximately 8" high by 12" wide in
the path of the beam. The Red Pilot Light on the
Allstar Access All-Clear™ Photosystem should go out.
The door should stop and reverse to the full open
position.
With the door fully open and at rest, place the obstacle
in the path of the beam once again. Activate the
Standard Wall Push Button. The opener should revert
to and remain in the PUSH AND HOLD mode of
operation for close travel.
IF THE GARAGE DOOR TRAVELS MORE THAN
ONE INCH IN A DOWNWARD PATH AFTER
RELEASING THE BUTTON, THE ALL-CLEAR™
IS MALFUNCTIONING. CHECK THE
ELECTRICAL CONNECTIONS AND ALIGNMENT
OF THE ALL-CLEAR™.
104393
F: OPERATION AND ADJUSTMENT INSTRUCTIONS