Filter
Top Products
15
INSTALLATION OF RADIO CONTROLS:
The following instructions detail installation of Allstar Model 9931 Radio Controls. For other Radio models, see instructions
packaged with product.
Setting The Coding Switches: When setting the Coding Switches THE FACTORY PRE-SET CODES MUST BE CHANGED TO
PREVENT UNAUTHORIZED OPERATION. Transmitter and Receiver codes must be set IDENTICALLY. If just one Code Switch
is mismatched, the Radio Controls will not function.
NOTE: For security reasons, it is advisable NOT to set all the switches in the same position.
Mounting The Receiver: After setting the
Coding Switches, mount the Receiver on
the rear panel of the Opener by connecting
it to Terminals 1, 2 and 3. A small Plastic
Pin is provided to secure the other end of
the Receiver to the panel. For proper
operation, the Antenna Wire should be
POINTED STRAIGHT DOWN toward
the floor.
After installing the Radio Controls, check
their operation by moving approximately
35 FT away from the garage door and
pressing the Transmitter Button. Operation at this distance should be reliable.
If the Transmitter doesn't activate door operation, check that all Coding Switches are set
identically. If the operational distance is inadequate, try moving the position of the
Transmitter in the car. If the distance is still inadequate, try bending the Antenna Wire to
a different angle. If the distance is still inadequate, replace the Battery with a standard 9-
Volt “transistor radio” Battery (NEDA 1604). The Battery is located in the front
compartment next to the Coding Switches.
The Transmitter may be hand held if desired by removing the Visor Clip from the rear of
the Case as illustrated. Place your finger in the loop at the top of the visor, and your
thumb on the top edge of the Transmitter. Push down with your thumb and pull up with
your finger. Clip will release and pull out easily.
WARNING
TO PREVENT THE RISK
OF PERSONAL INJURY,
DAMAGE TO DOOR OR
PROPERTY, ONLY
OPERATE DOOR
CONTROLS WHEN DOOR
IS IN CLEAR VIEW. KEEP
REMOTE CONTROL
AWAY FROM CHILDREN
IN SECURE AREA.
TRANSMITTER: To gain access to the
Transmitter Coding Switches, remove the
Battery Cover from the front of the
Transmitter by sliding it toward the
bottom of the Transmitter as illustrated.
RECEIVER: The Receiver Coding
Switches can be accessed by removing
the small door from the back of the
Receiver using a small screwdriver or
knife.
CODING BLOCK: Transmitter and
Receiver Coding Switches are contained
in identical Coding Blocks, consisting of
nine small switches, labeled 1 - 9, each of
which can be set in any of three positions,
labeled +, 0, -
104384
104385
104386
POINT ANTENNA
STRAIGHT DOWN
PLASTIC
PIN
104387
104388
D: AUXILIARY EQUIPMENT