Filter
Top Products
-6-
1. GENERAL WORKING PROCEDURE
1.1 Description
• Correct usage in accordance with design:
o The dirty laundry is loaded into the front part of the machine and the clean
laundry is unloaded from the rear part of the machine, using portholes
situated opposite to the loading ports (for the Aseptic machines) or into the
front part of the machine (for the CS machines).
o When a separating wall is constructed at the middle plane of the machine this
will then avoid any contact between the dirty and the clean laundry.
• Simple usage:
o Loading and unloading of the laundry through one or two large ports opening
by 180°.
• Easy-to-use programs:
o Control of the machine by a microprocessor with five standard programs -
washing types. It provides the possibility to create 25 other programs
according to your requirements.
• No concrete base is required. However, a stable and level floor is absolutely
necessary.
• No vibrations are transmitted to the floor.
• The machine only requires one electrical connection, one connection for the
heating system of the machine (electricity or steam or gas) and one channel for
the drainage of used water.
• Various types of detergents may be used:
o Classical detergent in powder form or liquid detergent supplied by a dosing
pump.
Note: The supplier of the liquid detergents must carry out the adaptation of the
dosing pumps and their electrical connection (since the system is specific for
each type of product).