Filter
Top Products
22
Document # 50075 Rev B 3/13/95
Programming Event Codes (99-168)
A description of the type of reports with reported 'event code' that are sent to the
central station appear in Tables 3-2 and 3-3. Entering a transmit selection of '0' will
cause the communicator to inhibit transmission of the report. Transmission of
reports to either or both central station phone numbers may be disabled.
Note the special 'System Abnormal Test Report' event code. This report was added
per new UL DACT requirements. This report is generated in place of the normal test
report when an alarm and/or trouble condition exists at the time the test report is
due to be sent.
Programming the Real-Time Clock
Entering an address greater than 172 will cause a display of the current time. On
initial power up, the clock will start running from the factory setting of 00:01
(military time). The far left digit will be flashing, indicating that this is the first digit
to be programmed.
Hours/Minutes
Select a digit then press [ENTER/STORE]. The digit 2nd from the left will start
flashing. Select a digit then press [ENTER/STORE]. Hours setting is complete.
With the digit 2nd from the right flashing, select a digit then press [ENTER/
STORE]. The digit on the far right will start flashing. Select a digit then press
[ENTER/STORE]. Minutes setting is complete.
End Programming
Exit Programming Mode by pressing MODE, followed by the 4-digit code
corresponding to an alternate mode of operation, then press [ENTER/STORE].
During Program Mode, if no key is pressed within 10 minutes, the UNI•COM will
revert to normal mode.