Resetting the patron counter
To keep track of the total count, record the number
on the patron counter before resetting the
detection system.
To reset the patron counter:
1
Locate the reset button access hole on the outside
of Panel A.
2
Straighten a small paperclip.
3
Gently push the paperclip
straight
into the access
hole approximately 1 in. (2.5 cm) until the reset
button clicks, and then remove the paperclip.
There is a guide within the access hole that
directs the paperclip to the reset button.
4
Confirm that the patron counter is reset to zero.
If the software version is displayed, press the
reset button twice in succession to clear the
screen.
Panel A
Access Hole
8800_OM_00
3
Figure 3. Locate reset button access hole.
Figure 4. Press reset button with paperclip.
9