Filter
Top Products
System Specifications
Detection zone
The primary zone of detection between the panels extends just above the
surface of the floor to 72 in. (1.82 m) above the floor. The electronic
coverage in this area is not 100%; however, the rate of detection is effective
to deter the loss of protected materials. It is also important to watch for
suspicious actions such as holding materials above or outside of the panels
when passing through the system.
Power requirements
Maximum current draw for all systems:
110/120 VAC: 500 mA
200/240 VAC: 250 mA
WARNING
To reduce the risks associated with hazardous voltage:
Do not use the product if the case, covers, or power cord are damaged;
Do not attempt to modify, service, or repair—no user serviceable parts inside—contact 3M
Service for repair.
Environmental (operation)
Typical ambient temperature range: 50° F (10° C) to 104° F (40° C)
Humidity: 0% to 85% relative humidity, non-condensing
CAUTION
To reduce the risks associated with environmental contamination from circuit boards
containing lead-bearing solder:
At the end of service life, dispose of the product according to federal, state and local
requirements.
Cleaning Instructions
Panel and base
Turn off the detection system prior to using liquid cleaners. Remove dirt and
greasy buildup using towels or soft cloths that have been dampened with a
common household grease-cutting liquid cleaner. 3M suggests a monthly
cleaning to retain the best equipment appearance.
Photocell lens and reflector
At least once a month, wipe the photocell lens and reflector with a soft cloth dampened with water.
7