A SERVICE OF

logo

Open as PDF
next previous
August, 2006 SCANNER UNIT
3-33
5. Position the 1st scanner [A] so the holes are aligned and insert the positioning
pins [B] (x2).
6. Position the 2nd scanner [C] so its holes are aligned and insert the positioning
pins [D] (x2).
7. Attach the lock bracket [E] to fasten the wire to the 1st scanner.
8. Tighten the screw of tension bracket ( Section 3.3.7).
9. Attach the pulley and tighten it lock screw ( Section 3.3.7).
10. Remove the positioning pins (x4).
11. Remove the tape from the pulley.
12. Slowly push the scanner left and right to confirm that the wires are engaged
correctly. The 1st and 2nd scanners should move smoothly.
B132R138.WMF
[A]
[B]
[C]
[D]
[E]