Using the Remote Control
Chapter 2 23
Tip
To turn off all the RCA, GE,
and Proscan components
that are connected to the TV,
press ON•OFF twice within
two seconds.
This feature only works with
most RCA, GE and Proscan
products.
PAUSE If you’re operating a VCR or DVD Player with the remote control, press PAUSE
when the disc or videotape is playing to pause playback.
PLAY If you’re operating a VCR or DVD Player, plays the disc or videotape.
REC•VCR+ When the GUIDE Plus+ program guide is on the screen, press REC•VCR+ to
program your VCR to record a program. If the remote is in VCR mode, press REC•VCR+
to start recording.
REVERSE If you’re operating a VCR or DVD Player with the remote control, press
REVERSE to go backwards on a disc or videotape.
SAT•CABLE Puts the remote in SAT•CABLE mode. If you set up the Auto Tuning
feature (Chapter 3), pressing the SAT•CABLE button automatically tunes the TV to the
correct channel.
SKIP If you press this button before you change the channel, the TV waits 30
seconds and automatically goes back to the original channel. Each time you press
SKIP, you add 30 seconds (i.e, if you press SKIP two times before you change the
channel, the TV waits 60 seconds and automatically turns back to the original
channel).
SOUND Displays the AUDIO PROCESSOR menu.
STOP If you’re operating a VCR or DVD Player, stops playing the disc or videotape.
TV Turns on the TV and puts the remote in TV mode. Also displays channel
information.
VCR1 Puts the remote in VCR mode. If you set up the Auto Tuning feature
(Chapter 3), pressing the VCR1 button automatically tunes the TV to the correct
channel.
VCR2 Puts the remote in VCR mode. If you set up the Auto Tuning feature
(Chapter 3), pressing the VCR2 button automatically tunes the TV to the correct
channel.
VOL (up and down) buttons Decrease or increase the TV’s volume.
WHO•INPUT In TV mode, press WHO•INPUT to toggle through the available Video
Input channels (VID, SVID, FRNT and the current channel). In SAT mode, press to select
available channel lists.
Using the WHO•INPUT Button
Use the WHO•INPUT button to toggle through the available input sources (VID, SVID,
FRNT and the current channel) and view the content from the component you have
connected to the TV.
1. Press TV to place the remote in TV mode. Make sure that the content from the
component is turned ON.
2. Press WHO•INPUT to tune to the available input source and view the component.
3. Press WHO•INPUT again to tune back to the channel you were previously
watching.
1569452A.02 Remote 4/9/02, 12:57 PM23
