11
This menu allows you to check the strengh of
the signal you are receiving through your aerial.
&
From the digital mode, press the
button to display the setup menu.
é Use the œ button to select installation
and pressÉ button to display the installation
menu.
“ Use œ button to select Test reception and
press Ébutton. You obtain an indication of
the actual programme frequency, the network
name, the signal quality and strength.
‘ You now have to enter the frequency of the
digital channel you want to test.
Your TV magazine can provide the list of digital
channel numbers. Use the table on page 30 to
get the frequency.
( If the signal quality and strength is poor, a
message appears at the bottom of the menu
prompting you to enter the frequency
between the lower and the higher limit. If
after keying the frequency, the reception is
still poor, you can try improving, renewing,
adjusting or updating the aerial. It is however
advisable to contact a specialised aerial
installer in order to achieve best results.
This menu allows you to select your preferred
language for audio, subtitle, teletext and menu
and make changes to the location (country
and time zone).
&
From the digital mode, press the button
to display the setup menu.
é Use the œ button to select preferences and
press É button.
“ Use œ button to select Languages, Location
or Digital Audio Output and press Ébutton.
‘ Use the o or œ button to select a setting and
press É button to enter into the sub-menu.
Make your adjustment and press
OK
button or
p button to exit.
Language default settings
• Audio : to select the audio sound language.
• Subtitle/Teletext : No function
(not applicable)
.
• Subtitling mode : No function (not applicable).
• Subtitles for hearing impaired : No function
(not applicable).
• System : to select the menu language.
Location settings
• Country : to select the country where you
are located.
• Time zone : to select the time zone where
you are located.
Digital Audio Output settings
To select AC3 (if the amplifier supports the
Dolby Digital format) or PCM (if it doesn’t
support Dolby Digital format).
NOTE : If you select AC3 sound, you must have
your TV conected to a Home Theatre System or
amplifier. In this mode, no sound will be heard
from the TV speakers directly.
( Press the
button to leave the menu.
Test reception
Language and location preferences
