- 33 -
Uploads motion/still pictures stored on this unit to WEB services.
“LUMIX CLUB” settings, etc. are required for uploading. (l 31) Refer to “Required settings
for sending data, etc.” (l 30).
≥ For more information, refer to the help of the Image App.
1 Tap .
≥ Thumbnails of motion picture or still picture stored in this unit are displayed. (l 27)
2 Tap and hold the thumbnail of the motion picture or still picture you
intend to upload.
≥ Tabs are displayed on four sides.
3 Drag and drop the thumbnail to the tab of the WEB service you
intend to use.
1 Tap .
≥ Thumbnails of motion picture or still picture stored in this unit are displayed. (l 27)
2 Tap and hold the thumbnail of the motion picture or still picture you
intend to upload.
≥ Tabs are displayed on four sides.
3 Drag and drop the thumbnail to the tab of the WEB service you
intend to use.
4 Enter a comment you intend to post on the WEB service.
5 Press the home button on the iOS device, and cancel the connection
between this unit and the iOS device (turn off the Wi-Fi setting).
≥ Set the internet environment, such as the 3G network connection, to the one for the iOS device.
6 Restart the Image App.
≥ When a message indicating that a connection attempt is being made with the camera is
displayed, close the message screen.
7 Tap on the top right of the screen, tap the motion picture or still
picture you want to upload from the list, and send it.
≥ After uploading, connect directly to the smartphone. (l 17)
≥ When using an access point connection (l 41), step 5 - 7 is not necessary if this unit and the
smartphone (iOS device) are connected to the same network. Uploading starts when comments
are entered.
Data uploading
Preparation: Connect this unit with the smartphone and start Image App. (l 17)
When using the Android device
When using the iOS device
1
HX-A100_VQT4X97.book 33 ページ ２０１３年２月１４日 木曜日 午後２時１６分
