- 31 -
2.2 PARAMETER FUNCTION DETAILS
2.2.1 Parameter list
Function
Parameter
No.
Name Setting Range
Minimum
setting
Increment
Factory Setting
Customer
Setting
–
1 Power supply frequency 1 (Note1) ––60.00Hz –
2 Power supply frequency 2 (Note1) ––50.00Hz –
Standard
operation
function
22 Overload signal detection level 0 to 200% 0.1 150.0%
Multi-
function
output
terminal
function
40 Output terminal assignment 0 to 33 (Note 6) 1 1
Display
functions
51 Input power monitoring reference 0 to 100kW 0.1
Rated power
(Note 2)
52 PU main display data selection 0 to 3333 (Note 7) 1 123
53 Input voltage monitoring reference 0 to 500.0V 0.1
220V/400V
(Note 3)
54 FM terminal function selection 0 to 3333 (Note 7) 1 123
55 Bus voltage monitoring reference 0 to 1000.0V 0.1
340V/680V
(Note 3)
56 Current monitoring reference 0 to 500.00A 0.01
Rated current
(Note 5)
Automatic
restart
function
57 Restart selection 0, 9999 1 9999
Operation
selection
functions
65 Retry selection 0, 1, 2, 3 1 0
67
Number of retries at alarm
occurrence
0 to 10, 101 to 110 1 0
68 Retry waiting time 0.1 to 360.0 s 0.1 s 1.0 s
69 Retry count display erasure 0 – 0
77 Parameter write disable selection 1, 2 1 2
Calibra-
tion func-
tions
145 Parameter unit language switching 0, 1, 2, 3 1 0
900 FM terminal calibration –––
Note: 1.You cannot set or change the values of Pr.1 “power supply frequency 1” and Pr. 2 “power supply
frequency 2”.
2.This set value varies with the capacity of the high power factor converter and is factory-set to the
rated power of the corresponding capacity.
3.These set values vary with the rated voltage of the high power factor converter and is factory-set
according to the 200V/400V class.
4.The set values of the half-tone screened parameters can be changed if “1” (write disable) is set in
Pr. 77 “parameter write disable selection”.
5.This set value varies with the capacity of the high power factor converter and is factory-set to the
rated current of the corresponding capacity.
6.Use numerals 0 to 3 to set a two-digit value in Pr. 40 “output terminal assignment”.
7.Use numerals 0 to 3 to set a four-digit value in Pr. 52 “PU main display data selection” and Pr. 54
“FM terminal function selection”.
Parameters
