A SERVICE OF

logo

PCI Adapter
1. Once you boot up your PC, Windows 98 will automatically identify the PCI
Adapter and prompt you to install the necessary driver. Insert the Setup
Utility CD (included) into your CD-ROM drive and click the Next button to
proceed.
2. Make sure Search for the best driver for your device is selected and click
the Next button.
5
Installing the PCI Drivers for Windows 98
Installing the PCI Adapter and
Network PC Card in Your Desktop PC
1. Turn off your desktop PC. (If you are just installing the WPC11 on your
notebook computer, please skip to the Installing the Network PC Card in
your Notebook PC section.)
2. With the PC Card facing up (the black arrow will be facing up), insert the
card completely into the PCI Adapter. These two devices must
be
installed together. While the card can be inserted either way, when it is
inserted properly, the “Instant Wireless” logo on the front of the card will not
be seen. If seen from the opposite side, only a small portion of the barcode
and no numbers
can be seen when the card is inserted completely. If in
doubt, try inserting the card both ways. The card will slide in further when
it is correct. Failure to insert the card properly will prevent the equipment
from functioning.
3. Open your PC case and locate an available PCI slot on the motherboard.
Check with your computer manufacturer for instructions.
4. Slide the PCI Adapter into the PCI slot. Make sure that all of its pins are
touching the slot's contacts. You may have to apply a bit of pressure to slide
the card all the way in. After the card is firmly in place, secure its fasten-
ing tab to your PC's chassis with a mounting screw. Then, close your PC.
5. Power on your desktop PC.
The Hardware Installation is complete.
4
Instant Wireless
TM
Series
Installing the PCI Adapter
WARNING:
For the PCI Adapter to be installed correctly, you must com-
plete the installation with the Network PC Card in place.
This card is not hot-swappable. Whenever you are ready to use
the Network PC Card in the PCI Adapter, you must boot up
your PC with the Network PC Card in place.