31
Initial Settings
TEST TONE
0ms
0ms
0ms
0ms
F.SP
C.SP
R.SP
S WOOFER
PRESS KEY
SPK.SETTING
EXPERT
LEVEL
DELAY
PREFERENCE1
PREFERENCE2
LFE
BASS
BASS
LFE
TEST TONE
Large
Small
Small
S woofer
F.SP
C.SP
R.SP
BASS
PRESS KEY
SPK.SETTING
EXPERT
LEVEL
DELAY
BASS
BASS
PREFERENCE1
PREFERENCE2
TEST TONE
0dB
0dB
0dB
0dB
F.SP
C.SP
R.SP
S woofer
PRESS KEY
LFE
BASS
BASS
SPK.SETTING
EXPERT
LEVEL
DELAY
PREFERENCE1
PREFERENCE2
● Bass Redirect Settings
If you are using small speakers that cannot reproduce low tones well, you can
redirect the bass audio to the subwoofer or front speakers.
1 Press 5/∞ to select [BASS].
2 Press 2/3to select the settings.
• S-woofer: Redirects the bass audio output to the subwoofer.
• L/R: Redirects the bass audio output to the front speakers.
If the front speakers are set to [SMALL], the bass audio is automatically
redirected to the subwoofer.
● Speaker LEVEL Settings
You can select the output level for each speaker, within a range of +6 dB to -6dB.
1 Press 5/∞ to select [Level], then press [ENTER].
The Level Settings screen appears.
2 Press 5/∞ to select the type of speaker.
• F.SP (Front speakers) is fixed at 0dB and cannot be adjusted.
3 Press 2/3 to select the desired output level.
• You can use the test tone to check the output level. See page 30.
4 Press 5/∞ to select [LEVEL], then press [ENTER].
The Level Settings screen closes.
● Delay Time Settings
You can adjust the delay time for each speaker.
1 Press 5/∞ to select [DELAY], then press [ENTER].
The Delay Time Settings screen appears.
2 Press 5/∞ to select the type of speaker.
• F.SP (Front speakers) and S.WOOFER (Subwoofer) are at 0ms and
cannot be adjusted.
3 Press 2/3 to set the desired delay time.
• You can adjust C.SP (Center speaker): within a range of 0ms to –5ms.
• You can adjust R.SP (Rear speakers): within a range of 0ms to –15ms.
• You can use the test tone to check the effect of the settings. See page 32.
4 Press 5/∞ to select Delay, then press [ENTER].
The Delay Time Settings screen closes.
XVD9000E_p25-32.p65 2/27/01, 2:38 PM31