14 EN
RECORDING
Basic Features
FEATURE: Zooming
PURPOSE: To produce the zoom in/out effect, or
an instantaneous change in image
magnification.
OPERATION: 36X Hyper zoom
Digital circuitry doubles the
maximum 18x magnification offered
by optical zoom.
1)To zoom in, slide the Zoom Lever
towards “T”.
2)To zoom out, slide towards “W”.
NOTES: ●
During Hyper Zoom, the speed
increases the further you slide the
Zoom Lever.
●
Focusing may be come unstable
during Hyper Zoom. In this case,
set the zoom while in Record–
Standby, set manual focus or Focus
Lock (
੬
pg. 18, 19), then zoom in
or out in Record mode.
●
The Zoom Level Indicator (
5
) only
moves during optical zoom. Once
the Zoom Level indicator reaches
the top of the zoom indicator bar,
all magnification from that point is
through digital processing.
●
During digital image processing,
the quality of the image may suffer.
FEATURE: Quick Review
PURPOSE: To check the end of the last record-
ing.
OPERATION: 1)Press “
” and release quickly
during the Record-Standby mode.
•Tape is rewound for about 2
seconds and played back
automatically, then pauses in
Record-Standby mode for the
next shot.
NOTE:
Distortion may occur at start of
playback. This is normal.
FEATURE: Retake
PURPOSE: To re-record certain segments.
OPERATION: 1)Make sure the camcorder is in the
Record-Standby mode.
2)Press either RETAKE button to
reach the start point for new
recording.
Pressing “F” fast-forwards the tape
and pressing “R” reverses it.
3)Press Recording Start/Stop button
to start recording.
NOTE:
Noise may appear during Retake.
This is normal.
Zoom-out
Zoom-in
Zoom indicator bar
Zoom Level
indicator
RETAKE (R/F)
Power zoom lever
