12 EN
25MIN
120MIN
119MIN
3MIN
2MIN
*-
-
-MIN
1MIN0MIN
RECORDING
Basic Recording (cont.)
Shooting while watching the LCD monitor
Before the following steps, perform step 1 (੬ pg. 10).
ENTER RECORD-STANDBY MODE
2
Make sure the LCD monitor is fully open. Slide the
LENS COVER open/close switch to open the lens
cover, then set the power switch to CAMERA.
•The power indicator lights and the camcorder
enters the Record-Standby mode.
•The scene you’re aimed at appears in the LCD
monitor, with the word “PAUSE” superimposed
upon it.
START SHOOTING
3
Tilt the LCD monitor upward/downward for best
viewability (੬ pg. 13) and press the Recording
Start/Stop button.
•The tally lamp lights while recording is in progress,
and “
REC
” appears in the LCD monitor.
STOP RECORDING
4
Press the Recording Start/Stop button again to stop
recording.
•The camcorder re-enters the Record-Standby
mode.
NOTES:
●
When you use the LCD monitor outdoors in direct
sunlight, the LCD monitor may be difficult to see. If this
happens, we recommend that you use the viewfinder
(
੬
pg. 10).
●
For other notes, refer to pg. 11.
LENS COVER
Switch
POWER
Start/Stop
Power indicator
MONITOR OPEN
Speaker
Tape remaining time indicator
Tally lamp
(Now calculating)
(Blinking) (Blinking)(Blinking)
