32 EN
01 02 03
05
04
EXIT
06
<
PROTECT
>
01 02 03
05
04
EXIT
06
<
PROTECT
>
I
S
P
D
ᮣ
N
L
R
E
R
D
I
O
L
E
E
D
T
E
T
X
E
E
T
U
C
E
R
S
T
N
M
H
E
O
N
W
U
Display
Power Switch
MENU Wheel
If Protection is
removed
PROTECT Menu
Normal playback
Padlock mark
Normal playback
Protecting Images
The Protect mode helps prevent the accidental erasure of
images. When a padlock mark is displayed next to the
Picture Mode indication, that image cannot be deleted.
1
Set the Power Switch to “ ”. If the DSC Lamp is
not lit, press REFRESH for approx. 1 second to select
“DSC”.
2
Press MENU. The Menu Screen appears.
3
Rotate MENU to select “PROTECT” and press it. The
PROTECT Menu appears.
TO PROTECT AN IMAGE
Before doing the following, perform steps 1 through 3
above.
4
Rotate MENU to move the frame to the desired image
and press it. A “ ” padlock mark appears on the
selected image.
Repeat this procedure for all images you do not wish
to delete by accident.
5
Rotate MENU upward to select “EXIT”, then press it
twice. The normal playback screen appears.
NOTE:
When the memory is initialised or corrupted, even
protected images are deleted. If you do not want to lose
important images, transfer them to a PC and save them.
TO REMOVE PROTECTION
Before doing the following, perform steps 1 through 3
above.
4
Rotate MENU to move the frame to the desired image
and press it. The “ ” padlock mark located above
the image disappears and the image is no longer
protected.
Repeat this procedure for all images from which you
wish to remove protection.
5
Rotate MENU upward to select “EXIT”, then press it
twice. The normal playback screen appears.
Menu Screen
REFRESH Button
D.S.C. PLAYBACK
(cont.)
Makes the DSC lamp
come on.
