Enable/disable surveillance
Set the surveillance time interval, in minutes
Set the surveillance delay, in minutes
The current settings are read from NVRAM and displayed on the screen. Any
changes made to the data shown are written to NVRAM.
Modem Configuration
Use this selection when setting the NVRAM for a modem attached to any of the
Service Processor's serial ports. The user inputs the file name of a modem
configuration file and the serial port number. The formatted modem configuration file
is read, converted for NVRAM than loaded into NVRAM. Refer to the "Service
Processor Installation and User's Guide" for more information.
Call In/Out Setup
This selection allows the user to display and change the NVRAM settings for the Call
In/Call Out capability of the service processor.
The settings allows the user to:
Enable/Disable call in on either serial port.
Enable/Disable call out on either serial port.
Set the line speed on either serial port.
Site Specific Call In/Out Setup
This selection allows you to display and change the NVRAM settings that are site
specific for the call in/call out capability of the service processor.
The site specific NVRAM settings allow you to:
Set the phone number for the service center
Set the phone number for the customer administration center
Set the phone number for a digital pager
Set the phone number for the customer system to call in
Set the phone number for the customer voice phone
Set the customer account number
Set the call out policy
Set the customer RETAIN id
Set the customer RETAIN password
Set the remote timeout value
Set the remote latency value
Set the number of retries while busy
9-12
7043 43P Series User's Guide
