Hunter Fan 42762-01 Manual

next previous

42762-01•07/19/07•HunterFanCompany

WARNING: Fan may fall if not assembled as directed in these

installation instructions.

3-1.Unbundlethewiresfromthefan.

For Standard or Angle mounting:

3-2. To assemble fan to hang down from a ﬂat or angled ceiling, insert

the downrod through the canopy. Feed the wires from the fan

through the downrod.

3-3. Loosen the square head set screw on the adapter to install the

downrod. Note: When the downrod is fully installed, 2-3 threads

onthepipewillstillbevisible;thisisnormal.Securelyretighten

the set screw with a wrench or pliers. Skip to Step 5-7.

CAUTION: e adapter has a special coating on the threads. Do

notremovethiscoating;thecoatingpreventsthedownrodfrom

unscrewing.Onceassembled,donotremovethedownrod.

For Low Proﬁle mounting:

Note: For low proﬁle mounting, the downrod is replaced with the

low proﬁle washer.

3-4. Removethesetscrewfromtheadapter.

3-5. Place the low proﬁle washer (lip down) into the canopy. Be sure

the green ground wire is pointing up toward the ceiling.

3-6.Aligntheholesinthewasherwiththeholesintheadapter.

Assemblesecurelywiththreelowprolescrews.

3-7.Raisethefanandplacethehookontheceilingplatethroughthe

round hole in the rim.

Steps 3-4 – 3-5

Low Proﬁle Screw

Low Proﬁle Washer

Steps 3-1 – 3-2

Downrod

Canopy

Step 3-6

Round

Hole

Set Screw

3 • Assembling and Hanging the Fan