Hunter Fan 42656-01 Manual

next previous

42656-01•08/14/09•HunterFanCompany

Step 7-1

HousingAssembly

Screw

Housing

7-1. Partiallyinstalltwohousingassemblyscrewsintothehousing.

7-2. Toattachthelightxture,connecttheupperplugconnector

from the motor to the lower plug connector in the light ﬁxture

assembly.

Note: Both plug connectors are polarized and will only ﬁt together

one way. Make sure the connectors are properly aligned before

connecting them. Incorrect connection could cause improper

operation and damage to the product.

7-3. Placethekeyholesinthelightxtureassemblyoverthepartially

installed screws in the housing.

7-4. Rotatethelightxtureclockwiseuntilthescrewsarermly

situated in the narrow end of the keyholes. Install the remaining

screw.Tightenallthreescrewssecurely.

7-5. Installthreecandelabrabulbs(40Wattmaximumeach).

Steps 7-2 – 7-4

Light Kit

HousingAssembly

Screw

Step 7-5

Candelabra

Bulb

HousingAssemblyScrew

7 • Installing the Light Fixture

Note: IncompliancewithUSfederalenergyregulations,this

ceiling fan contains a device that restricts the light kit to a

maximumof190Watts.Exceedingthatlimitorthemarked

limit on this product may result in ﬁre hazard or improper

operation.