A SERVICE OF

logo

Open as PDF
next previous
6
HunterFanCompany 42641-01•09/13/07
3 • Assembling the Fan
Steps 3-2 – 3-3
Low Profile
Washer
Downrod
Canopy
Set Screw
Low Profile Screw
WARNING:Fanmayfallifnotassembledasdirectedinthese
installationinstructions.
3-1.Unbundlethewiresfromthefan.
For Standard or Angled mounting:
3-2.Insertthedownrodthroughthecanopyandcanopytrimring.
Feed the wires from the fan through the downrod on one side of
thepinintheball.
3-3.Loosenthesquareheadsetscrewontheadaptertoinstallthe
pipeandballassembly.Note:Whenthepipeandballassembly
isfullyinstalled,2-3threadsonthepipewillstillbevisible;thisis
normal.Securelyretightenthesetscrewwithawrenchorpliers.
Goto4 • Hanging and Wiring the Fan.
CAUTION:eadapterhasaspecialcoatingonthethreads.Do
notremovethiscoating;thecoatingpreventsthedownrodfrom
unscrewing.Onceassembled,donotremovethedownrod.
For Low Profile mounting:
Note:Forlowprolemounting,thedownrodisreplacedwiththe
lowprolewasher.
3-4. Removethesetscrewfromtheadapter.
3-5.Placethelowprolewasherintothecanopywiththelipdown.
3-6.Aligntheholesinthewasherwiththeholesintheadapter.
Assemblesecurelywiththreelowprolescrews.
Goto4 • Hanging and Wiring the Fan.
Canopy
TrimRing
Green
Ground
Wire
Standard or Angled Mounting
Low Profile Mounting
Low Profile
Screws
Canopy
Canopy
TrimRing
Adapter
Low Profile
Washer
Low Profile Screw
Steps 3-5 – 3-6
Step 3-6 (Detail)