Hunter Fan 42641-01 Manual

next previous

42641-01•09/13/07 HunterFanCompany

2 • Installing the Ceiling Plate

CAUTION: Toavoidpossibleelectricalshock,beforeinstallingyourfan,

disconnectthepowerbyturningothecircuitbreakerstotheoutletbox

andassociatedwallswitchlocation.Ifyoucannotlockthecircuitbreakers

intheoposition,securelyfastenaprominentwarningdevice,suchasa

tag,totheservicepanel.

2-1. Drilltwopilotholesintothewoodsupportstructurethroughthe

outermostholesintheoutletbox.epilotholesshouldbe9/64”

indiameter.

For Angled Ceilings:Besuretoorienttheceilingplatesothatthe

twotabsarepointingtowardtheceilingpeak.

2-2.Yourfancomeswithfourpreinstallednoiseisolators.Checkto

make sure all four isolators are in place and were not removed

duringshipment.

2-3. Placeaatwasheroneachofthetwo3”woodscrews.

2-4. readthesupplywiresfromtheoutletboxintheceilingthrough

theholeinthecenteroftheceilingplate.

2-5. Aligntheslottedholesintheceilingplatewiththepilotholesyou

drilledinthewoodsupportstructure.Forproperalignmentuse

slottedholesdirectlyacrossfromeachother.

Note:eisolatorsshouldbeushagainsttheceiling.

2-6. Passthescrewsthroughtheslottedholesintheceilingplateinto

thepilotholesyoudrilled.

  Tightenthescrewsintothe9/64”pilotholes;donotuselubricants

onthescrews.Donotovertighten.

Flat Washer

3”Wood

Screw

Steps 2-3 – 2-6

Ceiling

Plate

For Angled Ceilings: Besuretoorient

theceilingplatesothatthetwotabs

arepointingtowardtheceilingpeak.

Toward

Ceiling Peak