Chapter 9 Remove/Replace Procedures
79
4. Remove the upper bezel.
5. At the rear of the CD-ROM, carefully disconnect the power and data cables.
6. Remove the CD-ROM by:
a. Pressing in on both release tabs to release the CD-ROM tray assembly.
b. Pull the CD-ROM assembly out of the chassis.
c. Remove the four screws, two from both sides of the CD-ROM tray.
7. Place the CD-ROM in an anti-static bag.
B
C
Removing the CD-ROM
Replacing the CD-ROM
1. Remove the CD-ROM from the shipping container.
2. Make any settings required by the CD-ROM documentation (primary or slave, etc.)
The CD-ROM is configured as the master device, unless a third HDD is installed, which should be
configured as the master device and the CD-ROM would be changed to the slave device.
3. If not already mounted, place the CD-ROM into the CD-ROM tray and secure it using the four screws.
4. Guide the CD-ROM tray into the chassis opening, with the cable connectors of the CD-ROM toward the
rear of the chassis.
The first CD-ROM is only mounted in the second shelf.
5. Push the CD-ROM tray all the way into the chassis until the CD-ROM tray snaps into place.
The two release tabs should click when in place.
6. At the rear of the CD-ROM, carefully connect the power and data cables.
