2-26
Installing the Series 8200zl Switch
Installation Procedures
Installing the Series 8200zl
Switch
Figure 2-13. Connecting the EPS to two 8200zl switches
These examples show the switch and the EPS using the J8713A power supply,
the J8712A power supply can also be used. It depends on how much PoE
power is required.
For more information on PoE requirements see the PoE (Power over
Ethernet) Devices Planning and Implementation Guide.
9. Connect the Network Devices
The type of network connections you will need to use depends on the types
of switch modules you have installed in your Series 8200zl Switch. See the
documentation accompanying the modules for cabling configurations and
procedures for those modules.
In general for all the modules, when a network cable from an active network
device is connected to the switch, the Link LED for the switch port should go
on. If the Link LED does not go on, use the table below to help solve the
problem, and see the module documentation for troubleshooting procedures.
EPS Cables
8200zl
8200zl
To Power Source
To Power Source
To Po w er
Source
To P o we r
Source
