Time Protocols
SNTP: Viewing, Selecting, and Configuring
CLI: Viewing and Configuring SNTP
CLI Commands Described in this Section
SNTP Command Page
show sntp 8-8
[no] timesync 8-9 and ff.,
8-12
sntp broadcast 8-9
sntp unicast 8-10
sntp server 8-10 and ff.
Protocol Version 8-12
poll-interval 8-12
no sntp 8-13
This section describes how to use the CLI to view, enable, and configure SNTP
parameters.
Viewing the Current SNTP Configuration
This command lists both the time synchronization method (TimeP, SNTP, or
None) and the SNTP configuration, even if SNTP is not the selected time
protocol.
Syntax: show sntp
For example, if you configured the switch with SNTP as the time synchroni-
zation method, then enabled SNTP in broadcast mode with the default poll
interval,
show sntp lists the following:
Figure 8-2. Example of SNTP Configuration When SNTP Is the Selected Time
Synchronization Method
8-8
