System Error Codes
2-17
HP DesignJets 1050C and 1055CM Printers Service Manual
System Error: 0C0032 (Continuable)
Problem
Description:
Drop Detector not Calibrated for all Printheads.
Corrective Action: Try the following:
Perform the Service Station Calibration ⇒ Page 5-11.
Replace the Drop Detector Assembly ⇒ Page 8-10.
If the Error Code continues, replace the Electronics Module ⇒
Page 8-25.
WARNING Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed.
System Error: 0C1000
Problem
Description:
Primer not Calibrated.
Corrective Action: Try the following:
Perform the Service Station Calibration ⇒ Page 5-11.
Make sure that the Primer Arm is not damaged. If the Primer
Arm is damaged, replace the Service Station ⇒ Page 8-8.
Replace the Electronics Module ⇒ Page 8-25.
System Error: 0C1001
Problem
Description:
Primer Shutdown Error.
Corrective Action: Try the following:
Check that the Primer Stepper-Motor Cable is NOT broken or
damaged and that the Primer arm moves freely from side to side.
Replace the Service Station ⇒ Page 8-8.
If the Error Code continues, replace the Electronics Module ⇒
Page 8-25.
WARNING Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed.
