Figure 32.
6.
Installing/Removing Headstock Center
Page 22
Note: Use the tool rest to support the opposite
end of the workpiece so that the workpiece
and spur center do not separate.
7.
Page 23
8.
9.
5.
Figure 32
Do not press the workpiece too firmly with
the tailstock or the bearings will bind and
overheat. Likewise, do not adjust too loosely
or the workpiece will spin off the lathe. Use
good reason and care, otherwise, serious
personal injury could result.
11.
Workpiece
Center Line
Distances
Tool Rest
1
/8"
1
/4"
Figure 33.
1
⁄4"
1
⁄8"
10.
Figure 33
Keep the turning tool on the tool rest
the ENTIRE time that it is in contact with
the workpiece. Otherwise, the spinning
workpiece could force the lathe tool out of
your hands or entangle your hands with the
workpiece.
